Bottom Bracket Selection Guide
Benchtop Preassembly of the BB and Crank is a Great Idea
Our One-Piece design, OPD, not only stops the creaks and makes bearings spin like mad, but it also makes bench pre-assembly possible. You can completely install the crank prior to pressing the module into your bike. Super handy.
This is one of the other luxuries of having a BBInfinite bottom bracket is because it's essentially a hub. The distance is already set just like that so you can do a bench top pre-assembly before you commit to putting it in the bike. So, you already know everything you're going to get for you need for your setup before you know you find like "oh I needed spacers." So you'll notice that there's just a little bit of play left that's built that's built in that's supposed to be there because that's meant to be taken up with this adjuster right here and you would put a lot of preload on this and tighten it down because remember this is a BBInfinite system so you can see the bushing in there just like that sometimes they float sometimes they're they hang in there pretty good and what this does is it prevents the inner races from being forced inward when you put a lot of when you put a lot of pressure on them actually axially like that and it would negate effects of a wave washer over compression and anyway and that's how you continue to get this good spin like this even when it has a ton of preload on it it's actually good for it
Leave a comment
Comments will be approved before showing up.